Poly Max Install
Poly Max Install Video Transcript
Method 1: Glue Mounting
Measure & mark distance to center of two panel
Measure & mark distance to top of panels
Mark the vertical center line with a level
Mark the top horizontal line with a level
Panel & Subfloor Adhesive & Spray Adhesive
“X-Plus” glue pattern
Apply Panel & Subfloor Adhesive in X-pattern
Apply Spray Adhesive in between Panel & Subfloor Adhesive lines
DO NOT Overspray Adhesive lines! Spray Adhesive must set for 4 minutes before mounting
Align panel edges to side vertical line & top horizontal line
Apply pressure on side & top to set edge adhesive
Apply pressure to set adhesive for remaining area
Adding Panels
Same glue pattern
Align edge side & top with installed panel
Apply pressure at adjoining side edge
Then apply pressure to remaining panel area
Also apply pressure to smooth out seam area
Method 2:
Z-Clip / Z-bar Mounting
Mount Z-Clips at top edge of pre-marked squared with center screws
With Z-Bar in place to level Z-Clips, add outside screws
Measure to bottom of top Z-Bar from top of panel, write it down
Measure to bottom of bottom Z-Bar from top of panel, write it down
Measure & mark side position
Measure & mark top position
Mark vertical line with level measurement
Mark horizontal line with level measurement
Measure down from top line for top Z-Bar placement
Use top written measurement
Measure down from top line for bottom Z-Bar placement
bottom written measurement
Mark the bottom Z-Bar line with a level
Mark the top Z-Bar line with a level
Mark the center of the top Z-Bar line
Mark the center of the bottom Z-Bar line
Punch the center and side holes for both top and bottom Z-Bars
Drill in the center and side wall anchors for both Z-Bar
Screw in the center and side screws for both Z-Bars
Hang the Poly Max Panel on the Z-Bars – Press down firmly after checking alignment